Stories

What changed after the brushes went down

Notes from operators who sat a workshop, clinic, or thermal visit—with the messy details left in.

“During the Hardware Maintenance Workshop we timed intake temps before lunch and again after the staged clean. The middle shelf dropped enough that we finally stopped arguing about whether dust mattered. I still wish we had practiced more on dual-connector fans—the last drill felt rushed.”

Dae-hyun S. — four-shelf ASIC corner, Dong-gu

“Fan Replacement Clinic was the right length. We caught two fans spinning the wrong way on a borrowed frame—embarrassing, but cheaper than learning that at 2 a.m. on our own.”

Nora M. — GPU open-air builder

“Jae-woo’s thermal assessment photos showed recirculation we had walked past for months. Paste intervals are on a calendar now. The visit fee hurt a bit for a small room, yet the annotated map is what our landlord finally understood.”

Park family farmette — Nam-gu

“Private group day let our three site leads argue through the same checklist. Cleaning is slower now, and that is the point—we stop when isopropyl pools instead of rushing the shift.”

Operations desk, coastal GPU co-op
Rack cabling and ventilation paths in a dense equipment room

Extended story

Summer humidity and a noisy third shelf

An Ulsan operator arrived at an on-site cleaning visit with a shelf that chirped only after midnight. Filters looked recently swapped. During the supervised clean we found felt compressed against an intake that looked clear from the aisle.

After reseating two fans and clearing the felt ridge, night noise dropped. The operator kept our filter-note template and booked a Fan Replacement Clinic the following month for the crew that rotates weekends. Not every bearing was saved—one fan still needed replacement—but the visit separated dust issues from dying motors.

Tell us about your shelves